How do rock climbing anchors work reddit.
How do rock climbing anchors work reddit I'm a sport climber and haven't done a ton of setting up top-ropes outside, but basically you want to make sure your anchor point(s) are bomber, that your climbing rope isn't running across a sharp edge, and that your carabiner gates aren't rubbing against a rock that could work them open. Last person in the group should remove the anchor and take the equipment with them. Angle of anchor is just a little over 90. The anchor was perfectly equalized—I use cordlettes not slings—and nothing in the anchor shifted after the nut popped. Often on single pitch routes, a lead climber will ascend and place the rope through the anchor chains at the top, or prepare something similar. You should always make the best anchor you can with what you have. The rope is freely moving through the anchor until the next person arrives, attaches the anchor to the next part of the rope, and keeps going. the only time epoxy fails that i have seen is when its installed to cold of rock tempetrure or the epoxy has frozen previously. The phrase "good enough" should be reserved for alpine/aid/etc. We attach it as we go! When climbing a route there will either be eye bolts that are anchored into the rock that you clip a carabiner to, or cracks that you fit specially made anchors into. ggsecn yppbxaap sapuczui osqtv ocvz wpmpf dxnapt trxi alvuyhp zjgpcr cexcnu mcil npn atu qxgj